Safety Procedures For Drilling Rigs

1. The drilling site should be kept clean.

2. When installing and disassembling the drilling rig, it is necessary to ensure that it is correct and complete.

3. When the mast of the drilling rig is lifted and lowered, the operator should stand in a safe position.

4. When starting the motor, all the friction clutches of the drilling rig should be turned on.

5. When the drilling rig is working, it is strictly forbidden to remove the protective cover.

6. Before the start of work, the reliability of the brake device should be checked, as well as the working performance of the friction clutch and starting device.

7. Before the motor is stopped, it is forbidden to check the drilling rig.

8. When the drilling rig is working, it is strictly forbidden to tighten any parts of the drilling rig.

9. When the drilling rig is running, it is strictly forbidden to refuel. Refueling of the upper pulley of the mast should be carried out when the drilling rig is stopped.

10. Before the motor is stopped, it is not allowed to work on the mast.

11. Under any circumstances, when there are people working on the upper section of the mast, no other personnel are allowed to stay under the mast.
12. In case of adverse weather (heavy rain, heavy snow, ice or strong wind of grade 5 or above), [3] Do not work on the mast. At the same time, it is not allowed to work on the mast with artificial lighting.
13. It is strictly forbidden to use wire ropes with split strands.
14. When the drilling tool is lifted and lowered, it is strictly forbidden to touch the wire rope by hand.
15. Except for drilling rig lifting, drilling pipe, etc., the wellhead is strictly forbidden to be open.
16. In order to prevent the shaking of drilling tools or pumping cylinders when they are taken out of the well from the well, it must be hooked with a hook made of steel rods with a diameter of 15~20mm.
17. When cleaning the drawer, a strong and reliable wire rope should be used to form a ring, put it on the lower end of the drawer, and turn it upside down.
18. When lifting or lowering the casing with a trolley, and when the machine is salvage work, all workers should leave the drilling.
19. When pulling out the casing with a crane, in order to avoid the casing falling off, it must be fixed together with each other.
20. When the lighting stops (at night), the drilling work should stop. At this time, when the drilling tool is still in the well, the drilling tool should be carefully removed from the well.